Metrohm tiamo 2.3 Manual - Manual (Page 766)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
750 ￭￭￭￭￭￭￭￭ tiamo 2.3
Temperature
Manually entered titration temperature. If a temperature sensor is connec-
ted and the Temperature measurement is set on the General/Hard-
ware tab under Sensor to automatic or continuous, then the temper-
ature will be measured continuously. This value is used for temperature
correction in pH measurements.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value 25.0 °C
Time interval measuring point
Time interval for entering a measuring point in the measuring point list.
Titrando, 855
Range
0.1 ... 999999 s
Default value 2.0 s
Titrino
Range
0.08 ... 16200 s
Default value 2.00 s
5.6.3.4.5.6 SET Ipol - Stop conditions
Tab: Method ▶ SET Ipol ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
The conditions for stopping the titration are defined on this tab. If more
than one stop condition is in effect at the same time, then the criterion
which is fulfilled first will stop the titration.
Stop volume
Stops when the given volume has been added after the start of the titra-
tion (including start conditions). The stop volume should be adapted to
suit the sample weight or the titration vessel size.
Titrando, 855
Range
0.00000 ... 9999.99 mL
Default value 100,000 mL