Candle KLVHSKONCT GC32-9172-00 - Manual (Page 199)

KM2EXPFF–KMCRCA002I 199
KMC0258W A Receiver/requester channel with the same name as this channel does
not exist on the receiving Queue Manager
@1 .
Explanation: You defined a value for the Connected Queue Manager on the
Transmit page for this channel. However, a receiver or requester channel with the
same name as this channel does not exist within the Queue Manager referenced
by the Connected Queue Manager. A sender or server channel must be able to
communicate with a receiver or requester channel of the same name.
User Response: Either blank out the Connected Queue Manager field, or
define a receiver or requester channel within the Connected Queue Manager that
has the same name as this channel.
KMC0259W The receiver/requester channel on Queue Manager @1 is defined with an
inconsistent transport type to this channel.
Explanation: You defined a value for the Connected Queue Manager on the
Transmit page for this channel. However, the corresponding receiver or requester
channel defined within the Connected Queue Manager specifies a different
Transport type.
User Response: Correct the definition of either this channel, or of the
corresponding receiver or requester channel on the other Queue Manager, so that
the transport types are consistent.
KMC0260W The maximum message length definition for this channel is inconsistent
with the receiver/requester channel on Queue Manager
@1 .
Explanation: You defined a value for the Connected Queue Manager on the
Transmit page for this channel. However, the corresponding receiver or requester
channel defined within the Connected Queue Manager specifies a different
maximum message length.
User Response: This message is only a warning. The maximum message
length is compared with the value for the partner and the actual maximum used is
the lower of the two values. To eliminate this warning message, correct the
definition of either this channel, or of the channel on the connected Queue
Manager.
KMC0261E Triggering is enabled for the queue but initiation queue @1 is not found.
Explanation: Triggering is enabled for the queue. However, the value that you
specified as an initiation queue did not reference a local queue on this Queue
Manager.
User Response: Either disable triggering for the queue, or identify the name of
a local queue defined on the Queue Manager which is to be used as the initiation
queue.
KMC0262E The initiation queue @1 associated with the queue is not
USAGE(NORMAL).
Explanation: Triggering is enabled for the queue. However, the value that you
specified as an initiation identified a local queue defined with Usage=Transmit.
User Response: Either disable triggering for the queue, or identify the name of
a local queue defined on the Queue Manager with Usage=Normal which is to be
used as the initiation queue.