Candle KLVHSKONCT GC32-9172-00 - Manual (Page 40)

40 Candle Products Messages Manual (KLVHS–KONCT)
KLVOP061 SYSTEM OPERATORS:
ID(operator) DEV(dev) PEND(pendnum)
LIMIT(oplimit)
.
.
.
Explanation: The CT/Engine OPERS command was issued. Each active
operator operator at logical unit dev is displayed. Fields of interest are the number
of characters comprising the pending messages pendnum and the maximum
number of characters that may be pending oplimit.
System Action: None.
User Response: None.
Message Type:
REPLY.
KLVOP071 PROFILE OPTIONS: [GLOBAL] [LOCAL] [FOLD arg] [SCP] [LIMIT=n]
Explanation: The PROFILE command was issued. The current operator
characteristics are displayed.
System Action: None.
User Response: None.
Message Type:
REPLY.
KLVOP081 MESSAGE FROM operator AT device message
Explanation: The SEND command was issued by operator operator at logical
unit device. Message message was sent to the current operator.
System Action: None.
User Response: None.
Message Type:
REPLY.
KLVOP082 OPERATOR operator NOT LOGGED ON
Explanation: The SEND command was issued specifying that a message be
routed to operator operator, but the operator was not logged on.
System Action: The command fails.
User Response: Validate the parameter operator using the OPERS command
and reissue the original command.
Message Type:
ERROR.
KLVOP101 APPLID applid NOT ACTIVE
Explanation: The LOGON command attempted to initiate a session between an
LU and an CT/Engine application applid that is not active.
System Action: The command fails.
User Response: Validate the applid parameter and re-enter the command. If
you receive the same message, the application in question is not active. You can
activate it using the OPEN command.
Message Type:
ERROR.