Candle KLVHSKONCT GC32-9172-00 - Manual (Page 419)

KMQxx001E–KOCJ0046 419
KN3SD002 ERROR PROCESSING AN SDM FUNCTION IN DIALOG calling_dialog —
APPL(SDM_application) SESSION(SDM_session_name)
FUNCTION(SDM_function_name) STATUS_ITEM(SDM_status_item)
RC(return_code)
Explanation: A generalized message generated only when there is a non-zero
return code from an SDM function call. The parameters have the following
meaning:
System Action: The SDM session was not established, but OMEGAMON II for
VTAM continues to operate.
User Response: Make sure that the SDM definitions are correct according to
the OMEGAMON II for VTAM Configuration and Customization Guide and the
customization guide for OMEGAVIEW or Status Monitor (depending on the
product installed).
Message Type:
Probable user error.
KN3SD003 [ENHANCED] | [ORIGINAL] ZOOM ACTIVATED
Explanation: The OMEGAVIEW enhanced or original zoom function has been
activated.
System Action: None.
User Response: None.
Message Type:
Information.
KO41031 Situation &1 is true.
Explanation: Situation &1 is occurring. This situation continues to be true until
message KO41032 is written to the Candle Management Server (CMS) product
log.
User Response: If you have AUTOMATED FACILITIES, you may want to
define or start a policy.
Severity: 0
System Programmer Response:No
KO41032 Situation &1 is no longer true.
Explanation: Situation &1 is no longer occurring.
User Response: View all error messages that were logged to the CMS product.
Message KO41031 shows you when situation
&1 became true.
Severity: 0
System Programmer Response:No
calling_dialog OMEGAMON II for VTAM dialog that calls this SDM function.
SDM_application Applid defined in the SDM product with which OMEGAMON II
for VTAM established the session to emit SDM status to the
SDM product.
SDM_session_name Name assigned to this session by the SDM product.
SDM_function_name SDM function requested.
SDM_status_item One of the status light items to be emitted to the SDM product,
such as the CTC TNSTATS light or the NCP TNSTATS light.
return_code Return code from the SDM function.