Candle KLVHSKONCT GC32-9172-00 - Manual (Page 357)

KMQxx001E–KOCJ0046 357
KN3CV142 UNABLE TO FIND THE ACTUAL RPL. THE CRPL IS DISPLAYED
INSTEAD. MOST OF THE DATA FROM THE ORIGINAL RPL CAN BE
FOUND IN THE CRPL
Explanation: The actual RPL was not available. The CRPL is shown instead.
The CRPL contains most of the data from the original RPL.
System Action: None.
User Response: Press Enter to continue.
Message Type:
Information.
KN3CV143 THE LOGMODE ENTRY FOR MODETAB tablename CANNOT BE
DETERMINED AT THIS TIME.
Explanation: The LOGMODE entry was not found in the MODETAB. The
LOGMODE entry was in an undetermined state at the time the request was made.
It is possible that the MODETAB was being dynamically refreshed or the session
was in a transitional state such as initiation or termination.
System Action: None.
User Response: Press Enter to continue. Try again later; a change in state may
synchronize the names.
Message Type:
Information.
KN3CV144 THE DATA FOR THE LOGMODE ENTRY entryname IS NOT AVAILABLE
IN THIS DOMAIN.
Explanation: The PLU is a cross-domain resource (CDRSC) and the
LOGMODE entry resides in the other domain. The name of the LOGMODE entry
displays. The MODETAB is available in the domain in which the PLU resides.
System Action: None.
User Response: Press Enter to continue. To view the table, log onto the
OMEGAMON II that monitors the other domain where the PLU resides.
Message Type:
Information.
KN3CV145 TUNING STATISTICS ARE NOT ACTIVE
Explanation: Tuning statistics are not currently active. If the VTAM command F
procname, NOTNSTAT was issued, VTAM stops recording tuning statistics,
OMEGAMON II for VTAM stops generating trend records for CTC, NCP, and
local devices and sets the three TNSTATS status lights on the Mains Status panel
to turquoise with text displaying NOTNSTAT.
System Action: None.
User Response: You can reactivate TNSTATS by entering the appropriate
VTAM command: F procname,TNSTATS
Message Type:
Information.
KN3CV147 TRACE ALREADY EXISTS
Explanation: The trace ID requested is already in use.
System Action: None.
User Response: Specify a unique trace ID, or if you want to restart the existing
trace, use the R (Restart) action code.
Message Type:
Information.