Candle KLVHSKONCT GC32-9172-00 - Manual (Page 62)

62 Candle Products Messages Manual (KLVHS–KONCT)
KLVOP963 COMMAND ERROR, RTM INTERFACE MAY BE SET “ON” OR “OFF”
Explanation: ON or OFF was not specified as the first positional parameter on
an RTM command.
System Action: The RTM command is not processed and the RTM interface
state is not changed.
User Response: Correct the command syntax and reissue the command.
Message Type:
ERROR.
KLVOP964 RTM rtm-name INTERFACE IS NOT SUPPORTED FOR VTAM LEVEL
version-level
Explanation: An RTM command could not be processed because CT/Engine is
executing under a release of ACF/VTAM™ that does not support the ETE or
NetSpy RTM interface.
System Action: The RTM command is not processed and the RTM interface
state remains inactive.
User Response: Identify the release of ACF/VTAM that you are running.
ACF/VTAM release 3.1.0 and above support the ETE or NetSpy interface.
Message Type:
ERROR.
KLVOP965 RTM rtm-name INTERFACE USEREXIT exit-name IS INVALID
Explanation: While processing an RTM ON command, the specified USEREXIT
could not be loaded into virtual storage, or the user exit module did not contain
an NOP instruction as the first word of the module.
System Action: The RTM command is not processed and the RTM interface
state remains inactive.
User Response: Verify that the user exit module was properly assembled and
link-edited into an accessible program library, and that the requirement for the
initial NOP instruction is met. Contact Candle Customer Support if you need
further assistance.
Message Type:
ERROR.
KLVOP966 COMMAND ERROR, RTM rtm-name IS UNKNOWN
Explanation: An RTM command specified a response time monitor whose
name is not recognized. NPM, ETE, and NetSpy are currently supported.
System Action: The RTM command in error is not processed and the RTM
interface state is not changed.
User Response: Correct the name and issue the command again.
Message Type:
ERROR.
KLVOP967 COMMAND ERROR, EXTERNAL NAME NOT VALID FOR RTM rtm-name
Explanation: An RTM ON command specified a parameter that is valid only for
the ETE or NetSpy interface.
System Action: The RTM command in error is not processed and the RTM
interface state is not changed.
User Response: Correct the name and issue the command again, or omit the
invalid parameter and issue the command again.
Message Type:
ERROR.