Candle KLVHSKONCT GC32-9172-00 - Manual (Page 38)

38 Candle Products Messages Manual (KLVHS–KONCT)
KLVOP031 REPEATING COMMAND SCHEDULED EVERY n
Explanation: The CT/Engine EVERY command was issued.
System Action: None.
User Response: None.
Message Type:
REPLY.
KLVOP032 ZERO INTERVAL NOT ALLOWED ON "EVERY" COMMAND
Explanation: The CT/Engine EVERY command was issued with zero as time
interval operand.
System Action: The "EVERY" command is ignored.
User Response: Re-issue the command with a non-zero time interval operand.
Message Type:
REPLY.
KLVOP033 TIME INTERVAL GREATER THAN 24:00:00 SPECIFIED
Explanation: The CL/ENGINE EVERY command was issued with a time
interval operand which evaluated to greater than 24 hours.
System Action: The "EVERY" command is ignored.
User Response: Re-issue the command with a time interval operand that
evaluates to less than 24 hours.
Message Type:
REPLY.
KLVOP041 SESSION PASSED: LU(luname) DEST(applid)
Explanation: LU luname was successfully passed to destination applid by the
LOGOFF command.
System Action: None.
User Response: None.
Message Type:
REPLY.
KLVOP042 UNABLE TO PASS SESSION: LU(luname) R15 (r15) SENSE(sensors)
Explanation: An unsuccessful attempt was made to pass LU luname to another
application by the LOGOFF command.
System Action: None.
User Response: Use IBM’s ACF/VTAM Programming and the r15 and SENSE
sensors
fields to determine the reason the CLSDST macro instruction failed and
take appropriate corrective action. The SENSE field format is explained in the
"CT/Engine Sense Data Format" appendix.
Message Type: ERROR.
KLVOP043 SESSION TERMINATION PENDING: LU(luname)
Explanation: The LOGOFF command was issued specifying termination of the
session between an active CT/Engine application and the logical unit luname.
System Action: The session between CT/Engine and luname is enabled for
termination. Termination is pending.
User Response: None.
Message Type:
REPLY.