Candle KLVHSKONCT GC32-9172-00 - Manual (Page 210)

210 Candle Products Messages Manual (KLVHS–KONCT)
KMC0341W The receiving Queue manager @1 is not a repository for the clusters
associated with the sender channel.
Explanation: You have defined a cluster sender channel; however, the Queue
Manager that the sender will connect to is not defined as a full repository for all
the clusters that the sender is associated with.
User Response: This message is a warning. Normally, predefined cluster
sender channels are only required to at least one Queue Manager which is acting
as a full repository for the cluster.
KMC0342W Duplicate cluster receiver channels were detected in the configuration
which match this cluster sender.
Explanation: You have defined a cluster sender channel; however, the
Configuration Manager found more than one cluster receiver channel on other
Queue Managers in the configuration which could match up with this cluster
sender.
User Response: This message is a warning. Duplicate cluster receiver names
can create confusion, and can prevent the configuration product from performing
complete validation. You might consider adopting a naming standard for your
cluster receiver channels that prevents duplicate names.
KMC0343E Cluster sender channels are not allowed on this version of MQSeries.
Explanation: You defined a cluster sender channel on a Queue Manager which
does not support them. Cluster sender channels are only supported on:
® MQSeries for MVS Version 2.1 and above.
® MQSeries for distributed systems versions 5.1 and above.
User Response: Either delete the cluster sender, or upgrade MQSeries to a a
version that supports clustering.
KMC0344E Cluster receiver channels are not allowed on this version of MQSeries.
Explanation: You defined a cluster receiver channel on a Queue Manager which
does not support them. Cluster receiver channels are only supported on:
® MQSeries for MVS Version 2.1 and above.
® MQSeries for distributed systems versions 5.1 and above.
User Response: Either delete the cluster receiver or upgrade MQSeries to a a
version that supports clustering.
KMC0345E Cluster and cluster namelist cannot both be specified.
Explanation: You defined a queue or channel which specifies both the Cluster
Name and Cluster Namelist properties. These properties are mutually exclusive.
User Response: Change the definition of the object so that either Cluster
Name or Cluster namelist is blank.