Candle KLVHSKONCT GC32-9172-00 - Manual (Page 75)

KLVHS001–KLVSC009 75
KLVRT020 RTM NPM SEND REQUEST FAILED: LU=lu-name APPL=applname
EVENT=X’xx’
Explanation: A non-zero return code was returned from the IBM-supplied
interface module FNMNSI because of a request error or an exceptional condition
where:
® lu-name is the physical terminal name.
® applname is the application name if applicable.
System Action: Processing associated with the request is terminated.
User Response: A list of return codes and reason codes can be found in IBM’s
NPM Installation and Customization
under the NetView® Synergy Interface
appendix. Contact Candle Customer Support if you need further assistance.
Message Type:
INFO.
KLVRT021 RTM NPM request FAILED: RC=nn REASON=nnn
Explanation: A non-zero return code was returned from the IBM-supplied
interface module FNMNSI because of a request error or an exceptional condition.
This message is produced for CONNECT and DISCONNECT requests.
System Action: Processing associated with the request is terminated.
User Response: A list of return codes and reason codes can be found in the
IBM manual NPM Installation and Customization under the NetView Synergy
Interface appendix. Contact Candle Customer Support if you need further
assistance.
Message Type:
ALERT.
KLVRT022 RTM NPM VECTOR ERROR
Explanation: CT/Engine detected an invalid internal NPM function call.
System Action: A call to NSI fails, CT/Engine creates a DUMP and continues
processing.
User Response: Contact Candle Customer Support with the contents of the
DUMP.
Message Type:
ABEND.
KLVRT023 RTM NPM NSI ADDRESS SPACE NOT RUNNING
Explanation: The NPM NSI address space is not running. NPM has rejected a
SEND, CONNECT, or DISCONNECT request by CT/Engine with a return code of
20.
System Action: The RTM interface in CT/Engine is terminated if active. If the
rejected request is CONNECT, CT/Engine sets a timer and retries the request
every 60 seconds.
User Response: Start the NSI address space and reissue the RTM ON
command.
Message Type:
ALERT.