Candle KLVHSKONCT GC32-9172-00 - Manual (Page 88)

88 Candle Products Messages Manual (KLVHS–KONCT)
KLVSE059 SENSE TABLE TOO LARGE, IGNORED
Explanation: The sense code table exceeds 2G bytes and cannot be built.
System Action: If this error is encountered during CT/Engine initialization,
only the default sense rules will be loaded. If this response was from a REFRESH
SENSE command then the currently active global sense table is not refreshed.
User Response: Contact Candle Customer Support.
Message Type:
ERROR.
KLVSE060 DUPLICATE LU ID FOR THIS SENSE CODE, THE FIRST IS RETAINED,
‘statement’, STATEMENT# nnn
Explanation: An LU ID was encountered that matches one already stored for
this sense code.
System Action: The processing actions specified on the first definition are
retained.
User Response: Remove the duplicate LU statement(s).
Message Type:
WARN.
KLVSE061 EITHER FROMAPPL OR FROMLU IS REQUIRED, ‘statement’,
STATEMENT# nnn
Explanation: FROMAPPL or FROMLU must be coded.
System Action: If this error is encountered during CT/Engine initialization,
only the default sense rules will be loaded. If this response was from a REFRESH
SENSE command then the currently active global sense table is not refreshed.
User Response: Add the required keyword and reissue the REFRESH SENSE
command.
Message Type:
ERROR.
KLVSE062 BOTH FROMAPPL AND FROMLU ARE NOT ALLOWED, ‘statement’,
STATEMENT# nnn
Explanation: FROMAPPL and FROMLU cannot be coded together.
System Action: If this error is encountered during CT/Engine initialization,
only the default sense rules will be loaded. If this response was from a REFRESH
SENSE command then the currently active global sense table is not refreshed.
User Response: Remove either FROMLU or FROMAPPL and reissue the
REFRESH SENSE command.
Message Type:
ERROR.
KLVSE063 KLVINSNS RKANPAR PARAMETERS:
Explanation: Module KLVINSNS logs its start-up parameters as they are read
from RKANPAR. This is the header message and will be followed by message
KLVSE064.
System Action: None.
User Response: None.
Message Type:
LOG.