Candle KLVHSKONCT GC32-9172-00 User Manual
Page 67
KLVHS001–KLVSC009
67
KLVPM011
TERMINAL luname LOGGED OFF - ERPCOUNT EXCEEDED
Explanation: A terminal, "luname", has caused more simultaneous error
recovery operations than the ERPCOUNT limit set by the PSM command.
"luname" is logged off.
System Action: None.
User Response: None.
Message Type:
INFO.
KLVPM012
PSM PRIVATE EXTENSION NOT INITIALIZED
Explanation: The PSM command was issued and the PSM private extension
was not available.
System Action: The PSM command is not executed.
User Response: Wait until CT/Engine has completed initialization, then reissue
the command.
Message Type:
INFO.
KLVPM013
PSM ERP INFO BLOCK POINTER IS ZERO
Explanation: The PSM command was issued and the PSM ERP block was not
available.
System Action: The PSM command is not executed.
User Response: Wait until CT/Engine has completed initialization, then reissue
the command.
Message Type:
INFO.
KLVPM021
INPUT PROCESSING EXCEPTION: RC=rc,lu_name,
modname,attention_code,fdbk, error_data,datastream
Explanation: An input message from the physical terminal has caused an
exception condition in PSM where
The following table lists possible reason codes for the input exception with
associated system action codes and user response codes. After locating the reason
code, refer to the appropriate system action and user response following this
table.
rc
Identifies the reason for the error. See the reason code analysis
table below for more information.
lu_name
Physical terminal LU name.
modname
Module identifier.
attention_code
Pending AID.
fdbk
Feedback information internal to CT/Engine.
error_data
Two bytes of error data. See the reason code analysis table below
for a description of the valid data.
datastream
Up to first ten bytes of the input message causing the exception.