Winco DGC-2020 - Manual (Page 181)

9400200990 Rev B DGC-2020 Modbus
™ Communication
B-23
Holding
Register
Parameter Range
Read/Write
Supported
Data
Format
Units
UNDERFREQUENCY
40630 81U Pick-up
450-550,
550-650,
3600-4400
R W
45.0-55.0 Hz for 50-Hz config.,
55.0-65.0 Hz for 60-Hz config.,
360.0-440.0 Hz for 400-Hz unit
40631 81U Time Delay 0-300 R W 0.0-30.0 seconds
40632 81U Inhibit Voltage 70-576 R W Volts AC
40633 81U Alarm Configuration 0-2 R W 0=None, 1=Pre-Alarm, 2=Alarm
OVERFREQUENCY
40634 81O Pick-up
450-550,
550-650,
3600-4400
R W
45.0-55.0 Hz for 50-Hz config.,
55.0-65.0 Hz for 60-Hz config.,
360.0-440.0 Hz for 400-Hz unit
40635 81O Time Delay 0-300 R W 0.0-30.0 seconds
40636 81O Alarm Configuration 0-2 R W 0=None, 1=Pre-Alarm, 2=Alarm
GENERATOR PROTECTION STATUS
40637
Gen Protection Status (upper 16
bits)
0-65535 R b16-b31 UNASSIGNED
40638
Gen Protection Status (lower 16
bits)
0-65535 R
b0 = overvoltage trip,
b1 = undervoltage trip,
b2 = overfrequency trip,
b3 = underfrequency trip,
b4 = overcurrent trip,
b5 = phase imbalance trip,
b6-b15 UNASSIGNED
40639
Gen Protection Pre-Alarms (upper
16 bits)
0-65535 R b16-b31 UNASSIGNED
40640
Gen Protection Pre-Alarms (lower
16 bits)
0-65535 R
b0 = overvoltage pre-alarm,
b1 = undervoltage pre-alarm,
b2 = overfrequency pre-alarm,
b3 = underfrequency pre-alarm,
b4 = overcurrent pre-alarm,
b5 = phase imbalance pre-alarm,
b6-b15 UNASSIGNED
40641
Gen Protection Alarms (upper 16
bits)
0-65535 R b16-b31 UNASSIGNED
40642
Gen Protection Alarms (lower 16
bits)
0-65535 R
b0 = overvoltage alarm,
b1 = undervoltage alarm,
b2 = overfrequency alarm,
b3 = underfrequencyalarm,
b4 = overcurrent alarm,
b5 = phase imbalance alarm,
b6-b15 UNASSIGNED
REAL TIME CLOCK
40700 Hours 0-23 R W
40701 Minutes 0-59 R W
40702 Seconds 0-59 R W
40703 Month 1-12 R W
40704 Day 1-31 R W
40705 Year R W
40706 Daylight Savings Time Enable 0-1 R W
0 = Off
1 = On
40707-57 RESERVED
ROLLING EVENT LOG ACCESS
40758 ECU Control Output Select 0-1 R W
0 = fuel solenoid relay,
1 = pre-start relay
40759 ECU Pulsing Enable 0-1 R W
0 = pulsing is enabled,
1 = pulsing is disabled