Winco DGC-2020 - Manual (Page 26)

2-4 DGC-2020 Human-Machine Interface 9400200990 Rev B
Sleep Mode
Sleep mode serves as a power saving feature. If the DGC-2020 is in Off mode or Auto mode not running
and a key is not pressed for more than 15 minutes, the front panel LCD backlight and LCD heater
(optional) are turned off. The DGC-2020 resumes normal display operation when any front panel button is
pressed or the genset is started remotely via the ATS input. If needed, Sleep mode can be permanently
disabled via BESTCOMSPlus or the front panel.
Changing a Setting
To change a setting, navigate to the setting you want to change and press the Edit key. If you are not
already logged in, you will be asked to enter your password at this time. Use the Up/Down arrows to raise
or lower the value. Press the Edit key again when finished.
Front Panel Display Structure
The front panel display begins with the SUMMARY SCREEN. Pressing the Right arrow key will open the
MAIN MENU screen. The MAIN MENU screen consists of METERING and SETTINGS. The METERING
screen branches are shown in Figure 2-2. The SETTINGS screen branches are shown in Figures 2-3
through 2-9.