Winco DGC-2020 - Manual (Page 91)

9400200990 Rev B DGC-2020 BESTCOMSPlus Software 4-41
Alarms
This screen indicates the status of Alarms, Pre-Alarms, Sender Fail, and Generator Protection. A green
LED indicates that the status is TRUE. Alarms and pre-alarms are reset when the DGC-2020 is set to the
Off mode. The Sync Fail at Gen Breaker, Gen Breaker Fail to Open, Gen Breaker Fail to Close, Sync Fail
at Mains Breaker, Mains Breaker Fail to Open, and Mains Breaker Fail to Close pre-alarms can be reset
by pressing the Reset key on the front panel HMI. Refer to Figure 4-44.
Figure 4-44. Metering, Alarms
Event Log
The event log provides a historical record of events detected by the DGC-2020. The user can download
data into BESTCOMSPlus and then save event logs as files. The Clear button gives the user the option of
clearing select or all event logs. Refer to Figure 4-45.
Figure 4-45. Metering, Event Log