Winco DGC-2020 - Manual (Page 85)

9400200990 Rev B DGC-2020 BESTCOMSPlus Software 4-35
Uploading a Firmware File to Device
If you have obtained an updated firmware file for your device, you may upload it by performing the
following steps:
1. Place the DGC-2020 in Off mode. This can be accomplished by clicking the Off button on the
Control screen inside the Metering Explorer or by pressing the Off button on the DGC-2020 front
panel.
2. Select Upload Firmware to Device from the Communication pull-down menu.
3. You will be asked to save the current settings file. Select Yes or No.
4. Select the communication port. Firmware updating is only possible locally through the USB port.
Refer to Figure 4-33.
Figure 4-33. DGC-2020 Selection Screen
5. Use normal Windows
®
techniques to browse for the updated firmware file that was obtained from
Basler Electric and click on the Send File button. Refer to Figure 4-34.
Figure 4-34. Upload Firmware Screen
Uploading Language Modules
The language of the front panel LCD can be changed by uploading a different language module into the
DGC-2020. The DGC-2020 is capable of storing two language modules in nonvolatile flash memory that
can be reprogrammed through the communication ports. The active language module being used for the
front panel LCD is selected on the Front Panel HMI setting screen. To access this screen, use the
Settings Explorer within BESTCOMSPlus to open the General Settings branch and select the Front Panel
HMI screen.
CAUTION
If power is lost or communication is interrupted during file transfer, the DGC-2020
will cease operating and will not recover.