Echelon IzoT Commissioning Tool - Manual (Page 120)

Wizard opens each time you add a router SmartShape to your OpenLNS CT drawing. See Using
Automatic Channel Selection for Routers in this section for how to enable this feature.
To add a router to an OpenLNS CT drawing, follow these steps:
1. Drag a Router SmartShape ( ) from the IzoT Commissioning Tool stencil to the drawing page.
The New Router Wizard opens unless you enabled automatic channel selection.
2. Enter the following information:
Router Name Enter the name of the router. This name must be unique within the
network. The router name may be up to 85 characters and include
embedded spaces, but it may not include period, backslash, colon,
forward slash, or double quote characters.
The default router name is “RTR- 1”. The instance number in the
default router name is incremented for each subsequent router you
create.
You can change this default naming convention by clicking Add-ins,
clicking IzoT Commissioning Tool, clicking IzoT Commissioning
Tool Options, and then selecting the Naming option from the
Options Category list.
See Naming Options in Appendix A for information on how to use
the options on this page to change the default naming convention.
Commission Router Select this check box to commission the router after defining it.
Type Select the channel type for each of the router’s two channels. By
default, each of these boxes displays the channel type of the channel
currently displayed in the Name list. You can use the Type list to
filter the existing channels in the Name list to those with a specific
channel type.
You can limit the channel types displayed by specifying the channel
types in a custom router SmartShape.
104 Designing Networks