Echelon IzoT Commissioning Tool - Manual (Page 234)

7. This dialog box displays the paths where the restored network database will be saved. You cannot
change the directory if the database already exists on your computer. Click OK. A message will
appear prompting you to select whether to delete or overwrite the existing directory.
8. Click Yes to delete the existing drawing folder before restoring the network, or click No to
overwrite it. The database restore operation begins.
9. When the network database has been restored, a confirmation dialog opens. Click OK.
Note: When you open a network restored from a hot backup of the network database, a message may
appear prompting you to resynchronize the OpenLNS CT drawing to match the database. This occurs
if changes were made to the drawing after the hot backup of the network database was created.
Restoring an IzoT Commissioning Tool Drawing Backup
To restore an OpenLNS CT drawing backup, follow these steps:
1. Open the IzoT Commissioning Tool Design Manager. Click Start on the taskbar, point to
Programs, point to Echelon IzoT Commissioning Tool, and then select IzoT Commissioning
Tool.
2. Select the OpenLNS CT drawing to restore from the Drawing Directory list.
3. Click Restore. The IzoT Commissioning Tool Restore dialog box opens, unless the currently
selected network does not have any backups saved in the default location. In this case, proceed to
step 6 to select the drawing backup to restore in the Select Backup File dialog.
4. Select the Restore from IzoT Commissioning Tool Backup check box.
5. If there is no file containing both network database and OpenLNS CT drawing backups, the Select
Backup File dialog opens. Otherwise, click Browse to open this dialog.
218 Maintaining Networks