Echelon IzoT Commissioning Tool - Manual (Page 72)

5. If you are opening an IzoT Commissioning Tool network after starting IzoT Commissioning Tool
for the first time, a message may appear asking you if you want to enable macros. You must
enable macros for IzoT Commissioning Tool to function. See Working with Digital Signatures for
more information.
6. Visio starts, your OpenLNS CT drawing opens, and the Server Location page of the Network
Wizard opens (unless you selected the Automatically Determine Server Location check box at
the bottom of this page when you previously opened the network).
By default, each subsequent page in the Network Wizard will appear every time you open the
OpenLNS CT drawing unless you previously selected the Skip This Prompt check box on the
page from the Network Wizard or from the Network Properties dialog in the drawing.
Tip: You can click Finish at any point in the Network Wizard to skip the subsequent series of
pages and open your IzoT Commissioning Tool network. Your IzoT Commissioning Tool
network will be opened using the settings in the Network Properties dialog in the drawing at the
time it was last saved.
7. Under Server Location, select the client type of the computer on which IzoT Commissioning
Tool is running. See IzoT Commissioning Tool Client Types for more information on each of
these client types.
• Select Local if IzoT Commissioning Tool is running on the same computer as the OpenLNS
Server.
• Select Remote Full Client if IzoT Commissioning Tool is running on a computer different
than the OpenLNS Server and the IzoT Commissioning Tool computer is attached to a
L
ON W ORKS channel through an IP-852 channel.
• Select Remote Lightweight Client if IzoT Commissioning Tool is running on a computer
different than the OpenLNS Server and the IzoT Commissioning Tool computer
communicates with the OpenLNS Server over TCP/IP.
56 Getting Started