Echelon IzoT Commissioning Tool - Manual (Page 171)

Image window.
• Upload from New App Image. The current device-specific
configuration property values in the selected application image file
will be written to the device.
This option is only available if you selected the check box to load
an application image into the device in the Device Application
Image window.
• Preserve Device Values. The current device-specific
configuration property values set in the device will be written to
the OpenLNS network database before the new application image
is loaded into the device. Once the new application image has
been installed, the device-specific configuration property values in
the OpenLNS network database are written to the new device.
This option is only available if you selected the check box to load
an application image into the device in the Device Application
Image window.
2. Click Next. If you are commissioning routers, the Initial Router State window opens. Otherwise,
the Device Identification Method window opens (in this case, see Selecting the Device
Identification Method to continue installing the devices).
Setting the Initial Router State
When the Router Initial State window opens, follow these steps:
1. Specify the initial state of the router by setting the following option:
State Set the initial state of the router. You have three choices:
• Default. The state of the router is determined by the current
setting in the New Device Options box located in the Network
Properties: Device options category. If the router was
previously commissioned and is able to communicate, the
default state is the state of the router before the current
IzoT Commissioning Tool User’s Guide 155