Echelon IzoT Commissioning Tool - Manual (Page 174)

To acquire the Neuron IDs and finish installing the devices, follow these steps:
1. Select any of the following service pin options
Options
Display Data
from Service Pin Select this check box to display a dialog that contains the information
returned in the service pin message. This check box is cleared by
default.
Filter on
Program ID Select this check box to ignore service pin messages that do not include
the same program ID as the device being commissioned. This option is
selected by default. This option is cleared if the application image will
be loaded during commissioning.
Filter on Channel Select this check box to ignore service pin messages that do not
originate from the same channel as the device being installed. This
check box is cleared by default.
On networks that use repeaters, IzoT Commissioning Tool cannot
always determine the source channel of the service pin message. For
these networks, it may be necessary to clear this check box in order to
commission the device.
The default value for this check box is set in the Network Properties:
Service Pin options category.
Total Received Indicates the total number of service pin messages received by IzoT
Commissioning Tool (including those ignored due to mismatched
program ID or channel).
If this number is incrementing when you press the service pin, but
IzoT Commissioning Tool is ignoring the service pin message, clear
both filter options and select the Display Data from Service Pin
check box. You may then compare the data received against the
expected data to analyze the problem.
2. Press the service pins of the devices you are commissioning.
3. If you are installing one device, IzoT Commissioning Tool will begin commissioning the device.
The total number of service pin messages received from the network will appear in the Total
Received box. When IzoT Commissioning Tool is done commissioning the device, it will return
to the OpenLNS CT drawing. The device SmartShape will be solid green (online) or crosshatched
green (soft offline), indicating that the physical device has been commissioned.
4. If you are installing multiple devices, IzoT Commissioning Tool will attempt to determine which
device you are commissioning based on the service pin message. If multiple devices qualify, IzoT
Commissioning Tool will select the first one that does not already have an assigned Neuron ID.
• You can specify which device or router you are commissioning by clicking its name under the
device name column and then pressing its service pin. If a service pin message is filtered or
IzoT Commissioning Tool is unable to identify the device, the number in the Total Received
box will be incremented, but no new Neuron ID will appear in the device list.
• As you press service pins, the total number of service pin messages received from the devices
you are commissioning will appear in the Total Received box. When all the Neuron IDs
have been acquired, IzoT Commissioning Tool will commission the devices. When IzoT
Commissioning Tool is done commissioning, it will return to the OpenLNS CT drawing. The
device SmartShapes will be will be solid green (soft online) or crosshatched green (offline),
indicating that the physical device has been commissioned.
5. Click Continue to quit pressing service pins and to commission the devices that have already been
acquired. Click Cancel to quit pressing service pins and not commission any devices.
158 Installing Networks