AGI Security SYS-16HN44P - Manual (Page 147)

135
Call Scan
In Figure 4-41, input Scan value and then click to call a tour. Click again to stop call.
Rotate
In Figure 4-41, click to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
 Preset, tour and pattern all need the value to be the control parameters. You can define it as y ou
require.
 You need to refer to your camera user’s manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-47.
Figure 4-47
4.8 Record and Snapshot
The record/snapshot priority is: Alarm->Motion detect->Schedule.
4.8.1 Encode
4.8.1.1 Encode
Encode setting is to set IPC encode mode, resolution, bit stream type and etc
From Main menu->Setting->System->Encode, you can see the following interface. See Figure 4-48.
 Channel: Select the channel you want.
 Type: Please select from the dropdown list. There are three options: regular/motion detect/alarm.
You can set the various encode parameters for different record types.
 Compression: System supports H.264, MPEG4, MJPEG and etc.
 Resolution: The
mainstream resolution type is IPC’s encoding config. Generally there is
D1/720P/1080P. For NVR42-4K, NVR42-8P-4K series product, the main stream supports 2048×
1536（3M）,1920×1080（1080P）, 1280×1024（S×GA）, 1280×960（1.3M）,1280×720（720P）,704
×576（D1）and the sub stream supports 704×576（D1）,352×288（CIF）.