AGI Security SYS-16HN44P - Manual (Page 191)

179
 UDP port: Default value is 37778.
 HTTP port: Default value is 80.
 HTTPS port: Default value is 443.
 RTSP port: Default value is 554.
Important: System needs to reboot after you changed and saved any setup of the above four ports.
Please make sure the port values here do not conflict.
Figure 4-101
4.12.1.3 WIFI AP
Note
This function is for some series product only.
The WIFI AP interface is shown as below. See Figure 4-102. Here you can set WIFI hotspot, so that the
network camera can use the hotspot to connect to the network.
 SSID: It is to set SSID name. You can use this name to search the device.
 Password: It is to set SSID password. You can use this password to connect to the network.
 Authentication mode: Select authentication from the dropdown list.
 Encrypt type: Select encryption type from the dropdown list.
 Start IP/End IP: Input start IP and end IP. The NVR can allocate the IP address in the range you
specified here.
 WPS: Click WPS button to enable WPS function. After the network camera enabled this function, it
can automatically connect to the network.
 Remote device: In the list, you can view the network camera(s) that connected to the NVR. It
includes signal intensity, IP, MAC address, bit rate, channel number, type, status and etc.