AGI Security SYS-16HN44P - Manual (Page 302)

290
Figure 5-103
Figure 5-104
Please refer to the following sheet for detailed information.
Parameter Function
Channel Select speed dome connected channel.
PTZ Type There are two options: local/remote.
Please select remote type if you are connecting to the network PTZ.
Protocol Select the corresponding dome protocol such as PELCOD.
Address
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Baud
Rate Select the dome baud rate. Default setup is 1115200.
Data Bit The value ranges from 5 to 8. Default setup is 8. Please set according
to the speed dome dial switch setup.
Stop bit The value ranges from 1 to 2. Default setup is 1. Please set according