Auto-Zone Control Systems Auto-Zone Plus Systems Installation & Operation (Version 03A) - Manual (Page 147)

Auto-Zone Plus Section 3
Programming 3-61
Min/Max Force Modes
CV Controller.................................. 29
Zone Controller............................... 37
Zone Manager ................................. 29
Minimum Damper/Airflow Setpoint
Zone Status...................................... 31
MINUS.................................................. 7
Minutes
Programming..................................... 8
Month
Programming..................................... 8
Neutral Mode
CVAHU .......................................... 39
New Passcodes.................................. 7, 9
No Auxiliary Heating
Zone Status...................................... 32
No Lockouts Active
CVAHU .......................................... 40
No Priorities
Zone Manager ................................. 15
NonVote.............................................. 35
Non-Voting Unit ................................. 35
OAT Broadcast Lost
Zone Manager ................................. 15
OAT Calibration ................................. 27
Occupied Mode
CVAHU .......................................... 39
Zone Status...................................... 31
Occupied Heating and Cooling Setpoints
CVAHU .......................................... 42
Zone Controller............................... 33
Occupied/Unoccupied Mode of
Operation......................................... 19
Open/Close Force Modes.................... 29
Zone Controller............................... 37
Operating Mode
AHU Controller .............................. 28
Operations
LCD/Keypad Summary................... 56
Optimal Start Menu
Zone Manager ................................. 49
Optimal Start Setpoints
Zone Manager ................................. 51
Outdoor Air
CVAHU .......................................... 40
Outdoor Sensor
CVAHU .......................................... 48
Parallel Fan On ................................... 32
Passcodes
Entering............................................. 6
PD ZONE ADDRESS................... 33, 34
PD Zone Cool Mode Min ................... 34
PD Zone Heat Mode Min.................... 34
PD Zone Max Damper ........................ 34
PD Zone Nite Mode Min .................... 35
PD Zone Vent Mode Min ................... 35
PI ZONE ADDRESS .......................... 33
PI Zone Cool Mode............................. 34
PI Zone Heat Mode ............................. 34
PI Zone Max Airflow.......................... 34
PI Zone Nite Mode.............................. 35
PI Zone Vent Mode............................. 35
PID Calculation Rate .......................... 24
Pressure Dependent............................. 29
Force Mode ..................................... 37
Pressure Dependent Zones
Setpoints.......................................... 35
Setpoints for.................................... 34
Pressure Independent .................... 29, 31
Force Mode ..................................... 37
Pressure Independent Zones
Setpoints.......................................... 35
Priority Cooling
Zone Manager ................................. 15
Priority Heating
Zone Manager ................................. 15
Prism ................................................... 38
Programming Setpoints......................... 3
Programming Date ................................ 8
Programming Passcodes ....................... 9
Programming Time ............................... 8
Proportional Constant ......................... 25
Push Button Override
CVAHU .......................................... 39
Pushbutton Override ..................... 31, 34
RAT Calibration.................................. 27
Read/Reset Units................................. 11
Read/Reset Address Entry .................. 11