Network requirements, Configuration procedure – H3C Technologies H3C MSR 50 User Manual
Page 236
# Configure the destination address and the destination UDP port number for the IPv6 NetStream
traditional data export.
[RouterA] ipv6 netstream export host 12.110.2.2 5000
IPv6 NetStream aggregation data export configuration
example
Network requirements
As shown in
, configure IPv6 NetStream on Router A so that:
•
Router A exports IPv6 NetStream traditional data to port 5000 of the NetStream server at
4.1.1.1/16.
•
Router A performs IPv6 NetStream aggregation in the modes of AS, protocol-port, source-prefix,
destination-prefix, and prefix. Send the aggregation data to the destination address with UDP port
2000, 3000, 4000, 6000, and 7000 for different modes.
All the routers in the network are running IPv6 EBGP. For more information about IPv6 BGP, see Layer
3—IP Routing Configuration Guide.
Figure 68 Network diagram
Configuration procedure
# Enable IPv6 NetStream in the inbound and outbound directions of Ethernet 1/0.
<RouterA> system-view
[RouterA] ipv6
[RouterA] interface ethernet 1/0
[RouterA-Ethernet1/0] ipv6 address 10::1/64
[RouterA-Ethernet1/0] ipv6 netstream inbound
[RouterA-Ethernet1/0] ipv6 netstream outbound
[RouterA-Ethernet1/0] quit
# In system view, configure the destination address and the destination UDP port number for the IPv6
NetStream traditional data export with IP address 4.1.1.1 and port 5000.
[RouterA] ipv6 netstream export host 4.1.1.1 5000
# Configure the aggregation mode as AS, and then, in aggregation view, configure the destination
address and the destination UDP port number for the IPv6 NetStream AS aggregation data export.
[RouterA] ipv6 netstream aggregation as
[RouterA-ns6-aggregation-as] enable
223