H3C Technologies H3C SecPath F1000-E - Manual (Page 160)

149
3. Check for the Remote Shell Daemon entry. If it does not exist, install the daemon first.
4. Look at the Status column to check whether the Remote Shell Daemon service is started. In this
example, the service is not started yet.
5. Double-click the Remote Shell Daemon service row, and then in the popped up Remote Shell
Daemon Properties window, click Start to start the service, as shown in Figure 70 .
Figure 70 Remote Shell Daemon Properties window
Configuring the SecPath
# Configure a route to the remote host. The configuration procedure is omitted.
# Set the time of the host remotely.
<SecPath>rsh 192.168.1.10 command time
Trying 192.168.1.10 ...
Press CTRL+K to abort
The current time is: 6:56:42.57
Enter the new time: 12:00
12:00