Sysname (host name or host ip address), Vendor id), Module – H3C Technologies H3C SecPath F1000-E User Manual
Page 72: Level (severity), Digest
61
Time stamp
parameter
Description Example
iso
Time stamp format stipulated in ISO 8601
Only the system information sent to a log host
supports this parameter.
<187>2009-09-21T15:32:55
Sysname %%10
IFNET/3/LINK_UPDOWN(l): Ethernet0/6
link status is DOWN.
2009-09-21T15:32:55 is a time stamp in
the iso format.
none
No time stamp is included.
System information sent to all destinations
supports this parameter.
% Sysname IFNET/3/LINK_UPDOWN:
Ethernet0/6 link status is DOWN.
No time stamp is included.
no-year-date
Current date and time without year
information.
Only the system information sent to a log host
supports this parameter.
<187>Aug 19 16:120:38
Sysname %%10
IFNET/3/LINK_UPDOWN(l): Ethernet0/6
link status is DOWN.
Aug 19 16:120:38 is a time stamp in the
no-year-date format.
Sysname (host name or host IP address)
•
If the system information that is sent to a log host is in the UNICOM format, and the info-center
loghost source command is configured, or the vpn-instance vpn-instance-name option is provided
in the info-center loghost command, the sysname field is displayed as the IP address of the device
that generated the system information.
•
If the system information is sent to a log host in the format of H3C, or is sent to other destinations,
the field is displayed as the system name of the device that generated the system information. You
can use the sysname command to modify the local system name. For more information, see Getting
Started Command Reference.
%% (vendor ID)
This field indicates that the information was generated by an H3C device.
It exists only in logs sent to a log host in the H3C format.
vv
This field identifies the version of the log, and has a value of 10.
It exists only in logs sent to the log host.
module
This field specifies the source module name. You can execute the info-center source ? command in system
view to view the module list.
level (severity)
System information is divided into eight severity levels, from 0 to 7. See
for more information
about severity levels. You cannot change the system information levels generated by modules. However,
you can use the info-center source command to control the output of system information based on severity
levels.
digest
This field briefly describes the content of the system information. It contains a string of up to 32 characters.