H3C Technologies H3C SecPath F1000-E - Manual (Page 74)

63
Outputting system information to the console
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 7 for default channel
names.
4. Configure an output channel
for the console.
info-center console channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the console through
channel 0 (known as console).
5. Configure an output rule for
the console.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "
Default output rules of system
information ."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The time stamp format for log, trap
and debugging information is date
by default.
7. Enable the monitoring of
system information on the
console.
terminal monitor
Optional.
Enabled on the console and
disabled on the monitor terminal
by default.
8. Enable the display of system
information on the console.
• Enable the display of
debugging information on the
console:
terminal debugging
• Enable the display of log
information on the console:
terminal logging
• Enable the display of trap
information on the console:
terminal trapping
Optional.
By default, the console only
displays log and trap information.
Outputting system information to the monitor
terminal
Monitor terminals refer to terminals that log in to the device through the VTY user interface.