Executing the configuration file – H3C Technologies H3C SecPath F1000-E User Manual
Page 232
221
•
If the IP address and the domain name of the TFTP server are not contained in the DHCP response
or they are illegitimate, the device broadcasts a TFTP request.
NOTE:
•
After broadcasting a TFTP request, the device selects the TFTP server that responds first to obtain the
configuration file. If the requested configuration file does not exist on the TFTP server, the request
operation fails, and the device removes the temporary configuration and starts up with factory defaults.
•
If the device and the TFTP server reside in different subnets, you must configure the UDP Helper function
for the gateway to change the broadcast TFTP request from the device to a unicast packet and forward
the unicast packet to the specified TFTP server.
Executing the configuration file
After obtaining the configuration file, the device removes the temporary configuration and executes the
configuration file. If no configuration file is obtained, the device removes the temporary configuration
and starts up with factory defaults.
NOTE:
The configuration file is deleted after executed, so save the configuration by using the save command.
Otherwise, the device has to perform automatic configuration again after reboot.