H3C Technologies H3C SecPath F1000-E - Manual (Page 69)

58
Information
channel number
Default
channel name Default output destination Description
8 channel8 Not specified
Receives log, trap, and debugging
information.
9 channel9 Log file
Receives log, trap, and debugging
information.
Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and configuration modules.
System information can be classified, filtered, and output according to source modules. You can use the
info-center source ? command to view the supported information source modules.
Default output rules of system information
A default output rule specifies the system information source modules, information type, and severity
levels for an output destination.
Table 8 shows the default output rules. The following describes default
settings:
• All log information is output to the Web interface and log file. Log information with a severity level
equal to or higher than information is output to the log host. Log information with a severity level
equal to or higher than information is output to the console, monitor terminal, and log buffer. Log
information is not output to the trap buffer and the SNMP module.
• All trap information is output to the console, monitor terminal, log host, Web interface, and log file.
Trap information with a severity level equal to or higher than information is output to the trap buffer
and SNMP module. Trap information is not output to the log buffer.
• All debugging information is output to the console and monitor terminal. Debugging information is
not output to the log host, trap buffer, log buffer, the SNMP module, Web interface, and log file.
Table 8 Default output rules
Output
destination
Modules
allowed
LOG TRAP DEBUG
Enabled/
disabled Severity
Enabled/d
isabled
Severity
Enabled/d
isabled
Severity
Console
All
default
modules
Enabled Information Enabled Debug Enabled Debug
Monitor
terminal
All
default
modules
Enabled Information Enabled Debug Enabled Debug
Log host
All
default
modules
Enabled Information Enabled Debug Disabled Debug
Trap buffer
All
default
modules
Disabled Information Enabled Information Disabled Debug