Magnum Energy ME-ARC Remote - Manual (Page 28)

22 © 2012 Magnum Energy, Inc.
3.0 Setup
Rotary SELECT Knob
LCD
Display
SETUP Button
Press to
select SETUP
menu
Press
SETUP
Rotate to
desired
selection:
Status...
01 Remote Setup
Top line shows
current status
Bottom line shows current
SETUP menu heading
Status...
01 Remote Setup
Status...
03 Charger Setup
Status...
05 BMK Setup
Status...
02 Invert Setup …...
Figure 3-6, SETUP Button and Menus
**IMPORTANT**
It is very important that you set the time clock as it is a critical piece in
effectively addressing fault issues, as well as for the proper start/stop
functions of your AGS device, if installed.
SETUP: 01 Remote Setup
The following menus are used to set up the remote screen and clock.
• 01A Set Clock – The ME-ARC contains a real time clock that must be
set for proper operation of some features. These features are: the SETUP
button’s 02C AC In-Time, 04B Gen Run Time, 04G Quiet Time, 4H Gen
Exercise menu items, and the 04 Fault History menu items under the
TECH button.
Info: The clock obtains power from the inverter and will reset if the
ME-ARC is disconnected from the inverter.
To set the current time:
From the Set Clock menu:
1. Rotate the SELECT knob to the correct hour of day, and then press
SELECT.
2. Rotate the SELECT knob to the correct minute setting, and then
press SELECT.
3. Rotate the SELECT knob to the appropriate AM or PM setting, and
then press SELECT.