Magnum Energy ME-ARC Remote - Manual (Page 8)

2 © 2012 Magnum Energy, Inc.
2.0 Installation
2.0 Installation
Review this section and the Important Product Safety Instructions on the
front inside cover before proceeding with the installation of your remote.
WARNING: Installations should be performed by qualifi ed per-
sonnel, such as a licensed or certifi ed electrician. The installer
determines which safety codes apply and ensures all applicable
installation requirements are followed. Applicable installation codes
vary depending on the specifi c location and application.
CAUTION: When connecting battery power to the inverter, all
battery negative connections must be connected prior to the bat-
tery positive connections. When removing battery power from the
inverter, the battery positive should be removed before any battery
negative connections are disconnected. This prevents any communi-
cation chips/lines from becoming the DC return path to the battery—
causing permanent damage to all connected accessories.
Summation: Ensure all battery negative circuits are always con-
nected before connecting or disconnecting battery positive.
2.1 Pre-Installation
Before proceeding, read the entire Installation section to determine how
best to install your ME-ARC remote. The more thorough you plan in the
beginning, the better your inverter needs will be met.
2.1.1 Installation Guidelines
• Before connecting any wires determine the remote’s cable route through-
out the home or vehicle/boat, both to and from the inverter.
• Always check for existing electrical, plumbing, or other areas of potential
damage BEFORE drilling or cutting into walls to mount the remote.
• Make sure all wires have a smooth bend radius and do not become kinked.
• If installing this remote in a boat, RV, or truck ensure the conductors
passing through walls, bulkheads, or other structural members are pro-
tected. This minimizes insulation damage (such as chafi ng) which can
be caused by vibration or constant rubbing.
2.1.2 Unpacking and Inspection
Carefully remove the ME-ARC remote from its shipping container and inspect
all contents. Verify the following items are included:
• The ME-ARC remote display
• Bezel
•
50’ remote cable
• Eight #8 x 3/4 Phillips screws
• ME-ARC owner’s manual
If items appear to be missing or damaged, contact your authorized Magnum
Energy dealer or Magnum Energy. Save your proof-of-purchase as a record
of your ownership; it is needed if the unit should require in-warranty service.
2.1.3 Tools Required
Installing the remote control is simple and requires the following tools:
• Phillips screwdriver • Level • Drill
• Cut-out tool (knife/saw) • Pencil • Drill bit (7/64”)