RIGOL DM3058 - Manual (Page 172)

RIGOL
Programming Guide for DM3058/DM3058E 5-23
Format Commands
1. FORMAT
Command Format:
FORMAT <frmt>
FORMAT?
Function:
The commands set and query the output format.
Explanations:
<frmt> could be 1 or 2. 1 denotes a measured value without unit, 2 permits the
unit following the value. For the relationship of each function and unit, see table
below:
Table 5-3 Units of format 2
Function Unit
DC voltage VDC
AC voltage VAC
DC current ADC
AC current AAC
Resistance OHMS
Frequency Hz
Diode VDC
Continuity OHMS
Note: Being restricted by working principle, command FORMAT <frmt> and
FORMAT? are only responsed without practical operation.