RIGOL DM3058 - Manual (Page 23)

RIGOL
Programming Guide for DM3058/DM3058E 2-14
1. SYSTem:BEEPer
Command Format:
SYSTem:BEEPer
Function:
The command tests the beeper.
Explanations:
The command issues a single beep immediately from the instrument. Note that
the beeper must be opened before using this command.
2. SYSTem:BEEPer:STATe
Command Format:
SYSTem:BEEPer:STATe?
SYSTem:BEEPer:STATe {ON|OFF|1|0}
Function:
The commands set and query the status of the beeper.
Explanations:
SYSTem:BEEPer:STATe? – Queries if the beeper is open.
SYSTem:BEEPer:STATe {ON|OFF|1|0} – Sets the beeper state. ON (1) is used to
open the beeper, and OFF (0) is for close. If the command
“SYSTem:BEEPer:STATe OFF” has been used, SYSTem:BEEPer would be invalid
when next use.
Return Format:
The query returns the current beeper state, 1 denotes ON and 0 denotes OFF.
Example
Opening the beeper.
SYSTem:BEEPer:STATe ON