Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 107)

IQOYA SERV/LINK user manual
107
9.2.2.2.2 Enable IP codec instances
After creation, the IP codec instances must be enabled to appear in the “Operations” page.
To enable IP codec instances, select them checking the box on the corresponding lines of the list, then open “For
selected IP codec(s)” menu at the top of the list and click “Enable” item.
Once enabled, the codec is added to the “Operations” page.
The enabled IP codec instances appear on the “Operations” page in the same order as they appear in the list. It
is possible to reorder the list clicking the “up” icon present at the beginning of each line:
Public IP address Read/Write Visible only if “Connection to public internet” is “From behind NAT
specifying public address”.
Enter the public IP address or domain name of the device.
STUN server address Read/Write Visible only if “Connection to public internet” is “From behind NAT using
STUN”.
This is the IP address or domain name of a STUN server.
STUN server port Read/Write Visible only if “Connection to public internet” is “From behind NAT using
STUN”.
This is the listening port of the STUN server.
Others
Fallback FEC scheme Read/Write The IP codec instance enables the FEC scheme given here when the
SIP signaling coming from a third party codec requires a FEC stream
without specifying any FEC scheme. In this case, the FEC scheme used
by the third party codec needs to match this fallback FEC scheme. Note
that this field is only relevant with SIP and has no use for a
communication between two Digigram’s codecs.