2 receive −> programs – Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) User Manual
Page 79
IQOYA SERV/LINK user manual
79
Click on “Save” to confirm the settings.
8.4.2 Receive −> Programs
Output programs are composed of a list of audio sources organized in priorities. Up to 3 decoding priorities can
be defined. The highest priority is priority 1. If the audio source of priority 1 is lost, IQOYA switches to priority 2 if
the corresponding audio source is available, or to priority 3 if the corresponding audio source is available. If no
declared audio source is available, the program output is silent.
Output programs configuration is accessible either from the left column
, or directly from the icon
“Go to IP Service” on the top right of the IP Services
.
The “Programs” page displays the declared output programs.
FEC stream parameters
Type
Description
Type
Read/Write
Select the FEC that is configured on the encoder of the received IP stream.
Payload type
Read/Write
Enter the same FEC payload type that is configured on the encoder of the received IP
stream.
Advanced mode
Read/Write
Select “Yes” if the FEC destination IP address is not the same as the IP stream destination
IP address, or of it is to be received on a UDP port different from “IP stream UDP port +2”
IP address
Read/Write
Displayed if Advanced mode is set to “Yes”.
In unicast, set the IP address to 127.0.0.1.
In multicast, enter the multicast IP address.
Listening port
Read/Write
Displayed if Advanced mode is set to “Yes”.
Enter the UDP port for receiving the FEC.