Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 98)

IQOYA SERV/LINK user manual
98
Parameter Type Description
Network interface Read/Write Select the network interface that will support the VLAN (Eth0, or Eth1)
VLAN ID Read/Write Enter the VLAN ID in the ranges [1-1001] [1006-4095]
Name Read/Write Enter a logical name for this VLAN
Status Read/Write Allows enabling/disabling this VLAN.
Select “Running” to enable this VLAN.
Select “Stopped” to disable this vLAN.
Priority Read/Write Enter the VLAN priority in the range [0-7].
IPv4 address Read/Write Enter the IP address of the selected Eth port in this VLAN.
If no value is entered, the IP address is the IP address of the selected
Eth port.
Netmask Read/Write Enter the netmask for this VLAN interface.
If no value is entered, the netmask is the same as the selected Eth
port netmask.