Iqoya serv/link user manual 74 – Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) User Manual
Page 74
IQOYA SERV/LINK user manual
74
Stream PID
Read/Write
Enter the PID of the elementary stream (16 to 8190)
PTS announcement period
Read/Write
Enter the Program Time Stamps announcement period (from 100 to 700 ms)
Language
Read/Write
Enter the language descriptor, according to ISO 639-2
Provider Name
Read/Write
Only available if DVB mode is set to “Yes”. This is the service provider name which is set in
the SDT table.
For adding another service in the MPTS stream, click on the icon
.
MPEG-TS Settings
Transport Stream ID
Read/Write
Unique identifier of a TS within an original network (from 0 to 65535)
PCR ID
Read/Write
Program Clock Reference
Select this option in case the PCR is sent as an elementary stream, and enter its packet ID
(16 to 8190)
PSI announcement period
Read/Write
Program Specific Information
Enter the announcement period (from 100 to 5000 ms)
Delay for PTS calculation
Read/Write
Enter the relative delay to be used to calculate the Presentation Time Stamp (100 to
2000ms)
Overall bit rate
Read/Write
Enter the overall bit rate of the MPEG-TS stream.
When set to 0, the bit rate is set automatically.
Transport Protocol
Read/Write
Streaming protocol of the MPEG-TS stream: RTP or UDP.
Number of TS packet per IP
packet
Read/Write
Sets the number of TS packets per IP packet. Default value is 7.
DVB Settings (if DVB Mode is set to “yes”).
Network ID
Read/Write
Network ID is used to identify the delivery system.
Original network ID
Read/Write
Network_id of the originating delivery system.
Network name:
Read/Write
Name of the network.
Audio Stream
When “DVB Settings” has been selected, select again “MPEG-TS settings” to access the Audio stream parameters.
IP address
Read/Write
Enter the destination IP address (unicast or multicast)
Port
Read/Write
Enter the destination UDP port.