Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 157)

IQOYA SERV/LINK user manual
16.6 Firmware v02.19c004- July 2019
16.6.1 What’s new since 2.18
● SSL certificate using public key encrypted with RSA 2048 bits
16.6.2 Fixed issues
● Log file was not restored after a boot cycle
● 1+1 redundancy option: Error message "Paired device cannot be reached" displayed when High
Availability service is running .
● 1+1 redundancy option: Audio breaks when the "slave" member joins the High Availability service .
● When using an AES/EBU input source, and when disconnecting it, the related vu-meter shows a fixed
level value instead of showing no level.
● Upload full configuration does not restore all the config files. No error seen on the WEB, but the new
configuration was not applied.
16.7 Firmware v02.18- March 2019
16.7.1 What’s new since 2.17
● Adds support for SNMPv3
16.8 Firmware v02.17a006- February 2019
16.8.1 What’s new since 2.16
● Support of the “High Availability” (1+1 redundancy) software option.
This allows using two identical SERV/LINK units in 1+1 hot redundant mode
16.9 Firmware v02.16c006- December 2018
16.9.1 What’s new since 2.15a
● Support of Pro MPEG COP#3.2 FEC for MPEG-TS streaming (Line, Column)
● Decoding of a stereo source (IP stream, local file) to a mono audio output or mono bus, with possibility of
mixing left and right channels with a fixed attenuation of 6 dB on each channel, and additional adjustable
gain.
● New “Loss” parameter management (Receive page) to avoid “long” audio breaks that were occurring after
the loss of a few IP frames.
With previous firmware versions, the “Loss” parameter, in the Receive page, could be set to Yes or No.
157