Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 138)

IQOYA SERV/LINK user manual
Basic network configuration
If your network switch has a mix of Gigabit and 100Mbps ports, make sure you connect SERV/LINK Dante’s port(s), and if possible all
devices, to the Gigabit ports.
● Make sure all computers are set to automatically configure their IP address.
● Power on the network switch
● Connect your Ethernet cables from each device to the Gigabit ports of the network switch. You may need to reboot the computers
if they have active previous IP network configurations. All devices will automatically be assigned IP network configurations.
● Use the Primary Ethernet port of the SRV/LINK (ETH0/PRI) to connect it to the Dante network.
Connection via a Redundant Network
The Dante redundancy works by using two completely independent and separate networks, the Primary Network and the Secondary
Network. To set up and use Dante Redundancy, connect your redundant Dante-enabled device using duplicate network switches and
Ethernet cables as shown below. Connect the following to the Primary Network only:
● Any computers running Dante Controller
● Any non-redundant Dante-enabled devices
All Dante-enabled devices that support redundancy should be connected to both the Primary and Secondary networks.
The primary and secondary networks MUST NOT be interconnected at any point.
138