Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 68)

IQOYA SERV/LINK user manual
68
Click on “Save” to confirm the settings. Click on “Save & New” to confirm the settings and create a new IP service
with the same parameters.
Click on “Close” to discard the settings.
Encapsulation = None and Transport protocol = UDP
Network interface/VLAN Read/Write Select the network interface or VLAN or bond for this FEC stream.
In case the target address is unicast, select “Any” so that the Eth interface is determined automatically
according to this IP address, or select a VLAN or a bond.
In case the target IP address is multicast, select the Eth interface or the VLAN, or the bond.
Local source port Read/Write Local UDP port number of IQOYA SERV/LINK
DSCP Read/Write Select the quality of service (QoS) class of the FEC stream.
Payload type Read/Write RTP payload of the FEC stream. Value 98 is recommended.
Parameter Type Description
Program
Name Read/Write Select the Program to be streamed from the list of Programs. A Program can be used by several
IP services.
Audio stream
IP address or Domain name Read/Write Destination IP address (unicast or multicast) or domain name.
Port Read/Write Enter the destination UDP port.
Network interface / VLAN Read/Write Displayed if a multicast destination IP address has been entered.
Select the network interface, or VLAN or bond that is to be used for streaming.
Audio stream: Local source port Read/Write Local UDP port number of IQOYA SERV/LINK
Audio stream: DSCP Read/Write Select the quality of service (QoS) class of the stream.