Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 97)

IQOYA SERV/LINK user manual
97
9.2.1.2 Connections −> Network −> VLAN
This page allows declaring VLANs on the Eth interfaces. No VLAN is declared by default.
Click on “+Add VLAN” to declare a new VLAN.
DHCP Read/Write Allows enabling/disabling DHCP (Dynamic Host Configuration
Protocol). Default value is OFF (disabled).
Click on “On” to enable DHCP. This mode disables the following
parameters.
IPv4 address Read if DHCP is On
Write if DHCP is Off
DHCP Off
Default value is 192.168.0.100 for Eth0, and 192.168.1.100 for
Eth1.
Enter the IP address of this Eth interface.
DHCP On
Displays the IP address automatically set through DHCP.
Subnet mask Read if DHCP is On
Write if DHCP is Off
DHCP Off
Enter the mask of the subnet this Eth port belongs to.
DHCP On
Displays the subnet mask automatically set through DHCP.
Gateway Read if DHCP is On
Write if DHCP is Off
DHCP Off
Enter the gateway IP address. Streams sent through this interface
will go through this gateway.
DHCP On
Displays the gateway IP address automatically set through DHCP.
Primary DNS Read if DHCP is On
Write if DHCP is Off
DHCP Off
Enter the IP address of the used DNS (if any).
DHCP On
Displays the IP address of the DNS set through DHCP.
Secondary DNS Read if DHCP is On
Write if DHCP is Off
DHCP Off
Enter the IP address of the secondary DNS (if any).
DHCP On
Displays the IP address of the secondary DNS set through DHCP.