Enterasys Networks Network Card - Manual (Page 109)

RiverMaster Administrator’s Guide
97
Chapter 4 Setting Trace Levels
Setting Up Aurorean Services
Setting Trace Levels
To set the trace level for any of the ten services, perform the following steps:
1 Open the Configuration pullout.
2 Click on the Activity icon in the lower left corner of the pullout to view
the Active Service List.
Figure 53 shows the Tunnel Management Service window with the
full Active Service List displayed.
3 Expand the tree list under Active Service List (click the + symbol).
4 Select the service of your choice.
Figure 53 ANG Tunnel Management Service Window
Click here to view the list of services
Click to open the
Configuration pullout
Select the Click here to
configure the
trace level
Click here to
expand the
tree list
service
Start or stop the trace service by clicking here
Set the Trace Level here