Enterasys Networks Network Card - Manual (Page 244)

232
RiverMaster Administrator’s Guide
Configuring Routing Protocols Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
3 Do one of the following:
– To allow the Aurorean Network Gateway to accept RIP updates
from all routers on the same subnet, no further work is required.
Skip to “OSPF Properties”.
– To configure “trusted” individual routers to supply RIP updates
to the Aurorean Network Gateway, click Add and continue with
the next step.
The Add A Trusted Gateway window appears as shown in
Figure 131.
Figure 131 Adding A Trusted Gateway for RIP
4 In the Address field, type the address for the router that the Aurorean
Network Gateway will accept updates from and click Add.
You can later modify this address or delete it using the Modify and
Remove buttons.
5 Repeat Step 3 and Step 4 for each gateway required.
6 Do one of the following:
– Click Apply to save your changes and Cancel to close the
window. If you want to configure OSPF on the ANG, continue
with the next section, otherwise skip to “Configuring Routing
Interfaces.”
– Click Cancel to close the window without saving your changes.
– Click Reset to return the RIP parameters to their default settings.
OSPF Properties
To enable OSPF on an interface, continue floppy disk configuration with the
following steps:
1 With the OSPF Configuration window displayed as shown in
Figure 132, type the area ID shared by the Aurorean Network
Gateway and routers within the subnet in the OSPF Area ID fields.