Enterasys Networks Network Card - Manual (Page 141)

RiverMaster Administrator’s Guide
129
Chapter 6 Creating a New Group
Managing Users & Groups
4 In the Description field, enter information that describes the members
of the group.
There is no character limit to descriptions, and they may contain
letters, numbers, and most symbols. This field is provided for
information purposes only, and does not affect authentication. Only
the first 24 characters are shown.
5 To enable client synchronization for this group, begin by selecting
Enable Data Synchronization.
When enabled, Data Synchronization automatically provides
members of this group with new policy settings, TollSaver POP
phone numbers and ISPs whenever they connect. Refer to “Client
Synchronization” on page 124 for more information.
6 Complete client synchronization for this group by clicking Enable
Software Synchronization.
When Software Synchronization is enabled, any new Prescriber
remedies and Aurorean application executable files are provided.
7 Determine how remote users are assigned IP addresses as follows:
– To assign a fixed IP address to each user in this group, select Use
Static User IP Addresses . When you add a user to this group,
you must assign that user a unique IP address as described in
“Adding Users to a Group” on page 134.
– To dynamically allocate IP addresses from a pool of addresses,
choose a virtual subnet from the Use Virtual Subnet for IP
Address Allocation
list. If this field is blank, you have not
defined any virtual subnets; refer to Chapter 3 for instructions on
creating virtual subnets.
8 Click the Dial tab and set the group’s dialing policies as described in
Table 5 and shown in Figure 68.
Dial policies affect Aurorean users that dial into ISP POPs using
analog modems. These policies specify whether those users can
change the ISP and POP dialing order, modify a POP phone number
before the modem dials it, and manually dial the POP using a
telephone.