8 click add – Enterasys Networks Network Card User Manual
Page 257
RiverMaster Administrator’s Guide
245
Appendix B
Creating Remote Connections
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
NOTE
A User specified here also must be added to the connecting Local ANG
User and Group database. Refer to Chapter 6, “Managing Users and
Groups,” for instructions. Also be aware that you cannot use this floppy
configuration utility to add Users and Groups to standalone ANGs which
terminate tunnels. Only the Aurorean Policy Manager can perform this
task. Refer to Chapter 3, “Configuring the ANG with Aurorean Policy
Manager,” in the Aurorean Installation & Service Guide for instructions.
5
Enter a Password and Confirm Password for this user in the fields
provided.
6
Select a tunnel Protocol (IPSec or PPTP) from the pull down list.
Between any two connecting ANGs in a fully meshed network, you
can select different tunnel protocols.
7
Select the Initial State you want this ANG to default to upon startup.
If your Local ANG is up and running, the Remote ANG will be
connected immediately with the default Initial State set to Enabled.
8
Click Add.
The new Remote ANG appears in the Remote Connection
Configuration window as shown in Figure 141.