4 do one of the following, Creating static routes, 1 open the configuration pullout – Enterasys Networks Network Card User Manual
Page 77: 3 expand the tree list under the name of your ang
RiverMaster Administrator’s Guide
65
Chapter 3
Routing
Configuring an ANG-3000/7000
4
Do one of the following:
–
Click Apply to save the OSPF parameter changes.
–
Click Cancel to close the window without saving your changes.
–
Click Reset to the return the interface’s protocol properties to
their default settings.
Creating Static Routes
To configure a static route between an ANG interface and another device,
perform the following steps:
1
Open the Configuration pullout.
2
In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3
Expand the tree list under the name of your ANG.
4
Click on Routing to display the routing parameter tab pages.
5
Click on the Interface tab to display the routing protocol(s) selected
for each interface.
6
From the Interfaces menu, choose the ANG Ethernet interface to
configure (External or Trusted).
7
In the Routing Protocol Selection list, double click Static Routes and
click Add in the Static Route Configuration window.
The Static parameter tab page is displayed as shown in Figure 38.