Enterasys Networks Network Card - Manual (Page 4)

Table of Contents
iv
RiverMaster Administrator’s Guide
Chapter 3 – Configuring an ANG-3000/7000
Before You Begin ................................................................................................................... 26
Allocating IP/IPX Addresses to Remote Clients....................................................... 27
Virtual Subnets for Site-to-Site and Remote Access Tunnel Servers.............. 30
Intelligent Client Routing ............................................................................................. 31
NAT Server...................................................................................................................... 33
Site-to-Site Tunnels ........................................................................................................ 34
AutoLink Recovery........................................................................................................ 35
General Aurorean Network Gateway Settings ................................................................. 37
Viewing Aurorean Alternate Address Information ......................................................... 42
Tunnel Protocols .................................................................................................................... 43
Virtual Subnetting ................................................................................................................. 50
IP Subnetting .................................................................................................................. 50
IPX Virtual Networks .................................................................................................... 52
Routing ................................................................................................................................... 54
Setting Routing Protocol Parameters .......................................................................... 55
Setting RIP Properties ........................................................................................... 55
Setting OSPF Properties ........................................................................................ 57
Routing Interfaces .......................................................................................................... 59
Adding or Removing a Routing Protocol for an Interface............................... 60
Configuring RIP for the Interface ........................................................................ 62
Configuring OSPF on an Interface ...................................................................... 64
Creating Static Routes ........................................................................................... 65
Adding a Remote Server ...................................................................................................... 68
Changing Server and Tunnel Properties..................................................................... 71