Enterasys Networks Network Card - Manual (Page 75)

RiverMaster Administrator’s Guide
63
Chapter 3 Routing
Configuring an ANG-3000/7000
NOTE
RIP update authentication is only supported by RIP Version 2. If the
routers on your network only support RIP Version 1, you cannot enter
values in the RIP Authentication fields. Refer to “Configuring RIP for the
Interface” on page 62 for instructions on selecting the version of RIP used
on your network.
4 Type the RIP authentication password used by routers on your
network in the Password field.
RIP authentication passwords are used by routers to determine if
they should accept updated routing information sent from another
router. If your routers do not authenticate updates, leave this field
blank and skip to Step 2.
5 Type the same password in the Re-Type Password field exactly as
you entered it in Step 4.
6 Set the RIP Route Importing/Exporting options as follows:
– To allow the ANG interface to learn new routes, place a check
next to Enable Import. If you enabled the Intelligent Client
Routing feature, you should turn on Enable Import to allow the
ANG to pass known reachable addresses to the remote client.
– To cause the ANG to advertise its known routes, place a check
next to Enable Export. This setting is required to allow the ANG
to advertise the reachability of virtual subnets to other devices on
the network.
7 Do one of the following:
– Click Apply to save the RIP configuration changes.
– Click Cancel to close the window without saving your changes.
– Click Reset to the return the interface’s protocol configuration to
its original setting.