Enterasys Networks Network Card - Manual (Page 252)

240
RiverMaster Administrator’s Guide
Configuring Routing Interfaces Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
NOTE
If you use static routes, the ANG will not broadcast IP pools. You must
add a static route on your internal router for that subnet. The internal IP
address of the ANG is the gateway.
To configure a static route between a Aurorean Network Gateway interface
and another device, perform the following steps:
1 In the Routing Configuration window, with the Interfaces tab selected,
choose the ANG Ethernet interface to configure (External or Trusted)
and click Add.
2 In the Routing Protocol selection list of the Add an Interface Route
Protocol popup window, double click Static Routes and click Add in
the Static Route Configuration window.
The Static parameter tab page is displayed as shown in Figure 137.
Figure 137 Static Routing Configuration Window